5. Preparation before Installation
Open the package and fetch out the product, firstly check the accessories. The
packing list shows as below.
EVERVOLT Home Battery System is 100% tested and packaged and visually inspected
before leaving our manufacturing facility. Please make sure the inverter is intact during
transportation. If there are some visible damages, such as cracks, please contact
distributor or Panasonic immediately.
5.1 Packing Lists of Inverter
DANGER!
Before installation, please make sure the breaker of battery is in “OFF”
position. During installation, make sure the battery terminal is not
short-circuited.
Preparation before Installation
20
In the inverter box
Site Requirements and Pre-installation Guidance
In the inverter accessory box
The installation position shall be well ventilated.
All indoor installations must be limited to a well-ventilated location in a garage
Ÿ Not be exposed to glare.
Ÿ Not in areas where highly flammable materials are stored.
Ÿ Not in potential explosive areas.
Ÿ Not near the television antenna or antenna cable.
Ÿ Not higher than altitude of about 9843 ft (3000 m) above sea level.
Ÿ Not in environment of precipitation.
Ÿ Not in areas without good ventilation.
Ÿ The ambient temperature in the range of –13°F (-25°C) to +140°F (+60°C).
Ÿ The slope of the wall should be within ±5°.
Ÿ Avoid direct sunlight, rain exposure, snow laying up during installing and
operating.
4.4 Installation Environment Requirement
No direct sunlight
No rain exposure
No snow lay up
Direct sunlight
Rain exposure
Snow lay up
Near antenna
Near combustibles
-25°C
+60°C
+140°F
-13°F
%RH
0
50
100
0-95%RH
21
A
B E G I J K
C L M N O P Q
D F H
or a structure detached from any living spaces
CAUTION!
Installation requirements may vary depending on where you live.
Ÿ Not in the basement.
To Next Page
Loading...