EVHB series only supports a certain type of lithium-ion battery
(Manufacturer certified battery)!
CAUTION!
Do not expose system to ambient temperatures above 140° F (60° C)
or below -13° F (-25° C).
WARNING!
Do not install the system in a corrosive environment where it may be
exposed to ammonia, corrosive gases, acids, or salts (eg: chemical
plant, fertilizer storage areas, tanneries, near volcanic ash eruption).
WARNING!
Safety
Safety
Do not disassemble any parts of the product which are not
mentioned in the installation guide. It contains no user-serviceable
parts. See warranty for instructions on obtaining service. Attempting
to service the device by yourself may result in a risk of electric shock
or fire and will void your warranty.
WARNING!
Do not operate the device when the device is running.
WARNING!
CAUTION!
Only accessories shipped with the product are recommended to use.
Using other accessories may void warranty.
CAUTION!
Possible damage to health as a result of the effects of radiation!
Do not stay closer than 7.87 in / 20 cm to system for a long time.
CAUTION!
Danger of burn injuries due to hot enclosure parts!
During operation, the enclosure may become hot.
CAUTION!
Risk of electric shock from energy stored in the capacitor.
Never operate on the inverter couplers, the Mains cables, battery
cables, and PV cables when power is applied. After switching off the PV,
battery and Mains, always wait for 5 minutes to fully discharge the
intermediate circuit capacitors discharge before unplugging DC, battery
and Mains couplers.
7
6
WARNING!
Do not attempt to open, disassemble, repair, tamper with or
modify the product. The product and its components are not
user serviceable.
The inverter input and output circuits are isolated from the enclosure.
This system does not include an isolation transformer and should be
installed with an ungrounded PV array in accordance with the
requirements of ANSI / NFPA 70, NEC 690.41.
Equipment grounding is the responsibility of the installer and must be
performed in accordance with all applicable Local and National
Codes.
WARNING!
Before operating the inverter, ensure that the inverter is grounded
properly. This product must be connected to a grounded, metal,
permanent wiring system, or an equipment-grounding conductor
must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the product.
WARNING!
When a ground fault is indicated, normally grounded conductors
may be ungrounded and energized or normally ungrounded
conductors may be grounded.
WARNING!
To Next Page
Loading...