57
INSTALLATION AND PREDELIVERY
OUTBOARD RIGGING
2
the key switch is on. Quick Connect-style network
does NOT use this connection.
Secure all cables with tie-straps.
If a CANbus water pressure gauge is used, install
Water Pressure Transducer Kit, P/N 5006214, in
the cylinder block.
install the transducer lead in the engine wiring har-
ness connector.
If a CANbus oil level gauge is used, an optional
CANbus oil level sender must be installed in the
oil tank. Connect the oil level sensor harness to
the boat CANbus network.
Use Evinrude Diagnostics software to activate
CANbus control functions in the EMM. From the
Settings screen, select Engine Options.
1. CANbus power supply connector 005269
1. Anchor points 005270
1. Water pressure transducer 004961
1
1
1
1. Water pressure transducer lead
2. Engine harness connector
004962
Engine Options Screen 006542
2
1
To Next Page
Loading...
