Chapter 3
Base Unit Hardware Description
3.3.6. Specific interfaces to 4-Ports Switch models (eWON Flexy 101 & 201)
4 x RJ45 ports switch LAN Ethernet 10/100.
The device LAN interface consists of a four ports auto-sense Ethernet switch (10/100 Mbps).
Auto-sense meaning that you can use both UTP Class 5 direct and crossed cables with RJ45
terminations at both ends. Default parameters see § #5.1.Factory Default IP settings.
The minimum required Ethernet cable type is Cat,5 with RJ45 connectors.
LAN1
Ethernet activity on port 1
Green steady = Ethernet link OK
Green flashing = Ethernet traffic (Rx and Tx)
LAN2
Ethernet activity on port 2
(same as above)
LAN3
Ethernet activity on port 3
(same as above)
LAN4
Ethernet activity on port 4
(same as above)
Page 19 / 40 eWON Flexy - Base Units | IG 014
To Next Page
Loading...
