11
EMPLOYER REQUIREMENTS
1. The employer will establish a procedure for the locking and tagging out of energy sources as required by OSHA.
2. The employer will provide training to all personnel involved in the operation, service and maintenance of the equipment.
3. The employer will monitor the employees operation of the equipment, ensuring that safe practices are being followed.
4. The employer will establish a program of regular inspections as outlined in the section CARE AND MAINTENANCE.
NOTE
These safety precautions do not imply or in any way represent an all
inclusive list. It is the owner's and operator's responsibility to be
familiar with and enforce that the unit is operated in accordance with
safety requirements and codes including all applicable Occupational
Safety & Health Act (OSHA) and American National Standards
Institute (ANSI) regulations.
These regulations change and therefore, it is impossible to give a
reference which will remain current. It is strongly recommended that
current OSHA and ANSI standards publications be available and
reviewed with operators at all times.
SAVE THESE INSTRUCTIONS
To Next Page
Loading...