21
12. Depress the green FORWARD button once again. The motor will start and the platen will move forward and then reverse
automatically after reaching full extension into the bale chamber. It will return to its retracted position and the motor will shut
off. If it does not, press the EMERGENCY STOP button. Adjustments may be needed to the rear limit switch. See the
ADJUSTMENTS section of this manual.
13. Cycle the baler again by depressing the green FORWARD button. When the baler is part way through its cycle, depress the
EMERGENCY STOP button. The motor should stop running and the platen should stop moving.
To Next Page
Loading...