EXCELL PRECISION CO., LTD.
45046
Place the container on the hook. When the weight indication is stable, press TARE key to
deduct the weight value of the container, and the “Tare” indicator switches on.
Place an object in the container, the scale will show the net weight value of the object.
Remove the full container and the display shows the negative weight value of the container.
Press TARE key to clear the weight value of the container, and the “Tare” indicator is off.
Continuous tare to tare value = maximum weighing capacity
Continuous tare Press TARE key to increase or decrease the container weight value
subtracted from the weight on the hook.
The TARE key will NOT be functional when the weight value of the container is over the
weighing capacity or the display shows a negative value when the scale is switched on.
But the negative weight appears after tare can continuously tare.
Take off any objects from the hook before cancelling the tare mode.
Hold key ( ) ---- Manual hold function
Press the HOLD key to hold and display the weight value. The “ZERO”, “MODE”, “TARE”,
and “STABLE” indication lamps will be lightened on the display. Press any key to cancel hold
function.
The hold function is available when the weight is negative.
1-7 Error Messages
Once the display shows , , , , please contact the dealer.
The weight value is over 9 division of maximum capacity.
Zero value is higher than10% FS.
Zero value is lower than 10% FS.
① Unstable condition when the scale counts back to zero.
② Unstable time is over 20 seconds after pressing ZERO or TARE key.
1-8 Self-Test Mode
Hold ZERO key and turn on the scale, SELF-TEST MODE is on when display shows .
To Next Page
Loading...
