EXCELL PRECISION CO., LTD.
45046
3-2 Display Description
1. "A2C11": firmware version of display controller
2. “SCAN”: scanning wireless FJ5
3. "CONN": connecting
4. "No BLE": can not scan wireless FJ5
5. "PR FAL": Pair fail
6. "PAIR": When pairing, please do not turn off FJ5 or display controller.
7. "OFF ": Display controller is off and in stand-by mode
8. "LOWBAT": Low battery, please charge
9. "RFWEAK": Wireless signal weak
10. "PR DEL": Clear paired devices
11. "SAVE ": Save paired devices.
3-3 Operating
Please turn FJ5 on before operating.
1. Press ON/OFF key to turn on the display controller.
2. Display “A2C11””SCAN” “CoNN” “9,8…0”“weight”.
3. When linking, the display counts down to zero. If it can not connect to the corresponding FJ5
in 15s, display controller will automatically turn off.
4. When connected, link indication is steady until signal becomes weak, then it will starts
flashing.
5. The function of 4 keys ( [MODE , HOLD , ZERO , TARE ) is the same with FJ5.
6. If display controller disconnects with FJ5 over 20s, for example beyond signal range or turn
off FJ5 manually, it will be turned off automatically.
7. Press BL key to turn on/off the backlight.
8. Press ON/OFF key once to turn off the display controller and FJ5 together. Display shows
“oFF“. If press ON/OFF key for 3s, it will restart display controller.
9. When low battery indication (1) on, Please charge the display controller. When low battery
indication (3) appears, please turn off FJ5 and charge it immediately.
Enter self-test mode: turn on the display controller, while it counts down to zero, press
ZERO key.
When in power-save mode (FnC 01), display controller shows scrolling "-" if idle for a long
time.
To Next Page
Loading...
