25 FPM-600/FLS-600
Measuring Power or Loss (FPM-600)
Referencing Your Power Meter to a Source
5. Repeat the procedure for each wavelength you want to reference (if
you use auto-switching mode, the power meter automatically
references wavelengths one at a time).
Note:
When using dB units, press to display the current wavelength for a
few seconds. To change this wavelength, press again while it is
displayed.
Note:
Once all desired wavelengths have been referenced, do not disconnect the
Reference Test Jumper from the source port.
To Next Page
Loading...
