Accessing Your Unit Remotely
188 FTB-1v2 and FTB-1v2 Pro
Working with Remote Desktop
To access your unit remotely with Remote Desktop:
1. Connect both the computer and your unit to the same network and
make sure they can “see” each other as network restrictions might
prevent them from communicating.
If you want to use an Ethernet network, connect an RJ-45
(network) cable to the unit’s Ethernet (RJ-45) port located on its
right panel.
If you want to use a wireless network, see Connecting to a Wireless
Network on page 160.
2. Turn on both the computer and the unit.
3. On your unit, from Mini Toolbox X, tap the button (located at the
bottom of the button bar).
4. Select the Platform tab, write down the IP address, and then close the
window.
Note: It may take a few seconds before you see the IP address on the list.
To Next Page
Loading...
Need help?
General
