EXFO FTB-1v2 - BIEEE 488.2 and Specific Command Reference; IEEE 488.2 Commands-Quick Reference

FTB-1v2 and FTB-1v2 Pro 385
B IEEE 488.2 and Specific
Command Reference
This chapter presents detailed information about the commands and
queries supplied with your FTB-1v2 and FTB-1v2 Pro.
IEEE 488.2 Commands–Quick Reference
The FTB-1v2 and FTB-1v2 Pro recognizes the required commands
identified in IEEE 488.2. The table below summarizes these commands.
These commands are fully explained on the following pages.
Command Function
*CLS Clear status command
*ESE Standard event status enable command
*ESE? Standard event status enable query
*ESR? Standard event status register query
*IDN? Identification query
*OPC Operation complete command
*OPC? Operation complete query
*RST Reset command
*SRE Service request enable command
*SRE? Service request enable query
*STB? Read status byte query
*TST? Self-test query
*WAI Wait for pending operations to be completed