25
INSTALLATION AND START UP
Drain connection checklist
1. Connect one end of the exible drain tube
to the drain cup outlet. (It is located under
the drip tray and grill. Contact a service
technician to do this task you are unsure
how to access this area of the machine.)
2. Connect the other end of the drain tube
to the domestic plumbing drainage system
in the service area.
3. Replace/reinstall the drip tray and grill.
Flexible drain tube
Drain cup
1. Ensure that a water ltration device
or system is installed in-line in the
domestic water supply ahead the machine
to prevent contamination inside the
machine’s hydraulic system. Contact a
service technician to do this task if you
are not confident about performing the
steps below.
2. Open the water tap and allow the lter
to ll (if new/previously unused). Then
the machine’s steam boiler will begin to
ll. Check carefully around the service
area for leaks or drips. If leaks/drips are
detected turn off the tap immediately and
check/tighten any leaking ttings.
Water filtration checklist
Pro Tip:
Always maintain the water ltration device or system in accordance with the manufacture’s
specications. Failure to routinely maintain the ltration device or system will result in limescale
build-up inside the machine’s hydraulic system which will eventually result in machine failure.
Domestic
water supply
Machine
Water
filter
Pro Tip:
Ensure that the drainage tube is not twisted and that it is below the level of the drain cup to
prevent trapping water and other residue in the tube which could mold or produce bad smells.