45
USER PROGRAMMING - ONYX Pro
Adjusting dose programming
Use the following steps to program the espresso brew dosages for each brewing group and drink button
(each button can be programmed for a different dosing time if desired):
1. Press the Settings button for six seconds until the user programming menu appears on the
touchscreen.
2. Press the Dose Programming button, then press the drink button to be programmed on each
brewing group.
3. Use the
+ and - buttons to adjust the dosing volume to the desired amount, repeat for each
drink button.
4. Then press the Exit
button to conrm the volumes and exit.
Note:
Programming any of the options on the left-side brewer bank’s buttons automatically
programs the dispensing volumes for the corresponding button on all of the other
groups. This only applies to the left-side brewer buttons. Programming other drink
buttons only modies the option selected. So we programming doses for each group,
always program the left-side brewer buttons rst, then program the other group(s).
Note:
For safety and water conservation, all brewing settings have a maximum dispensing time
of 5 minutes.
i
i
Powering the machine OFF/ON from the touchscreen
To power the machine down at the end of a use period without using the main switch do the following:
1. Press the Settings button for six seconds until the user programming menu appears on the
touchscreen.
2. Press the Power button, the touchscreen with illuminate red to indicate that the machine
is powered off. To turn the machine back on, simply press the Power button again while the
touchscreen is illuminated in red.