IN1606 and IN1608 Series Scaling Presentation Switcher • SIS Configuration and Control 45
X2&
= Screen saver mode 1 = black output (default)
2 = blue output
X2*
= Video output mute 0 = unmute
1 = mute video
2 = mute video and sync
X2(
= Auto-Image threshold value 0-100 (where 0 = black and 100 = white;
025 = default)
X3)
= HDCP status 0 = no sink or source device detected
1 = sink or source detected with HDCP
2 = sink or source detected but no HDCP
X3!
= Video switching effect 0 = cut
1 = fade through black (default)
X3@
= HDMI output format 0 = auto (based on the display EDID: default)
1 = DVI RGB 444
2 = HDMI RGB 444 “Full”
3 = HDMI RGB 444 “Limited”
4 = HDMI YUV 444 “Full”
5 = HDMI YUV 444 “Limited”
6 = HDMI YUV 422 “Full”
7 = HDMI YUV 422 “Limited”
X3#
= Default name A combination of model name and the last three
pairs of the device MAC address (for example,
IN1606-07-8C-EC)
X3%
= Audio input type 0 = none (input muted)
1 = analog (default for inputs 1 and 2)
2 = LPCM-2Ch digital (default for inputs 3 and
higher)
3 = Multi-Ch digital
4 = LPCM-2Ch digital auto
5 = Multi-Ch digital auto
X3^
= Video signal status 0 = video or HDMI signal not detected
1 = video or HDMI signal detected
X3&
= Power save mode 0 = full power mode (default)
1 = lower power state
X3*
= Screen saver status 0 = active input detected, timer not running
1 = no active input, timer running, output sync
still active
2 = no active input, timer expired, output sync
disabled
X3(
= HDCP authorization status 0 = block HDCP encryption
1 = allow HDCP encryption (default)
X4)
= IP address xxx.xxx.xxx.xxx
(192.168.254.254 = default)
X4!
= Subnet mask xxx.xxx.xxx.xxx (255.255.0.0 = default)
X4@
= Gateway address xxx.xxx.xxx.xxx (0.0.0.0 = default)
X4#
= MAC address
00-05-A6-xx-xx-xx
X4$
= Number of open connections
0-<maximum number of open connections>
X4%
= Config type 0 = IP config
1 = device-specific parameters
To Next Page
Loading...
Need help?
General
