EasyManua.ls Logo

Extron electronics TLS 520M - Page 15

Extron electronics TLS 520M
73 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Room Scheduling System • Panel Overview 9
5
Full day (
. . .
) button (see figure 3 on page 7) — Touch this button to display a
timeline of the full day availability for approximately 5 seconds (see figure 4). You can set
the starting and end time of the timeline.
91011121 23456789876
1111111111
Figure 4. Today’s Availability Display
Touch on the
Today’s Availability timeline (figure 4,
1
) to temporarily pop up
an inset (figure 5,
A
) showing just the availability of a block of time. This inset has no
controls within it, but the scroll left ( ) and scroll right ( ) buttons (
B
) on either side of
the inset allow you to step the time that is displayed in the inset backward and forward.
AAAAAAAAAA
BBBBBBBBBBB
BBBBBBBBB
Figure 5. Today’s Availability Inset Display and Scroll Buttons
NOTE: If the panel has no connection with the calendar server, the Full day button
is displayed in red (
. . .
) and the timeline that pops up displays no meaningful data.
6
Reserve button (see figure 3) — This button appears on the room available display
when two conditions are met:
The room is available in the selected 30-minute block on the timeline (see
4
on the
previous page).
The button is programmed to appear using the Room Agent software (see Layout
tab on page 37).
Touch the button to reserve the room for the selected 30-minute block. The panel
displays the red
Room unavailable flag (
3
) for the selected 30-minute block and
the meeting subject field, if enabled (see Layout tab) displays the walk-up Subject
message. The default message is “adHoc,” but this can be changed.
7
Extend button (see figure 3) — This button appears on the room unavailable display
when two conditions are met:
The room is available directly after the unavailability selected on the timeline (
4
).
The available block can be:
The selected 30-minute block if the unavailability is less than 30 minutes.
The 30-minute block directly after the selected block if the unavailability is in a
full 30-minute block.
The button is programmed to appear using the Room Agent software (see Layout
tab).
Touch the button to extend the reservation until the next top or bottom of the hour (X:00
or X:30) for the selected 30-minute block.