version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 103
Removal at end of life product
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel, familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• The system must cool down.
• The product must be removed.
• The used CGG must be put it in the box in which it was supplied and returned to the
distributor of the applicable country (see a list at www.exxfire.com).
Removal at end of life CGG
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel, familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• Where on-site CGG replacement is necessary; a CGG will be provided as a replacement unit.
As this is not protected by an outer enclosure, further care must be taken to handle it
appropriately, especially after it is removed from its transport packaging.
• The qualified installer (distributor) has a decommissioning tool with which he can
decommission the system manually.
• The system must cool down.
• The CGG’s must be removed from the product,
• In case of a Used generator please ship them back to your local Distributor (see list on
website www.exxfire.com)
• Order a New and Unused generator and re-use the original packaging for shipping the Used
generator
• Take out the Unused generator from its UN certified packaging and install them in the EXXFIRE
fire protection system
• Take out the sticker for the return shipment of the Used generator and place them on the UN
certified box over the existing print
To Next Page
Loading...