version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 28
Personal protective equipment
The personal protective equipment mentioned in this section must be used in the event of a
hazardous situation. In normal circumstances, only safety shoes are required.
Respiratory protection: In case of contact with grain inside CGG
Hygiene measures (apply in any case)
• Handle in accordance with good industrial hygiene and safety practice. Wash hands before
breaks and at the end of the workday.
• Do not inhale released gas
Prescribed personal protective equipment
▪ Where risk assessment shows air-purifying respirators are
appropriate, use a full-face particle respirator type N100 (US) or type
P3 (EN 143) respirator cartridges as a backup to engineering controls.
▪ If the respirator is the only means of protection, use a full-face
supplied air respirator.
▪ Use respirators and components tested and approved under
appropriate government standards such as NIOSH (US) or CEN (EU).
▪ Hand protection, in case of contact with grain inside CGG.
▪ The selected protective gloves should satisfy the specifications of EU
Directive 89/686/EEC and the standard EN 374 derived from it.
▪ Eye protection, in case of contact with grain inside CGG:
▪ Safety glasses with side-shields conforming to EN166.
▪ Skin and body protection, in case of contact with grain inside CGG:
▪ Choose body protection according to the amount and concentration of
the dangerous substance at the workplace.
To Next Page
Loading...