version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 115
Disposal at end of life CGG
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel, familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• Where on-site CGG replacement is necessary; a CGG will be provided as a replacement unit.
As this is not protected by an outer enclosure, further care must be taken to handle it
appropriately, especially after it is removed from its transport packaging.
• The CGG’s must be removed from the product,
• The replacement CGG’s come with a special 4G UN box and a plastic bag. Put the used
CGG’s into the plastic bag and then into the 4G UN box.
• Call the distributor of the applicable country (see a list at www.exxfire.com).
• The distributor will organize the collection of the used generators in the respective
catchment area/region/country and takes care of the chemical waste disposal process on
behalf of EXXFIRE.
Disposal of defective product
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• After removal, put the defective product in the box in which it was supplied (a 4G UN box)
and return it to the distributor of the applicable country (see a list at www.exxfire.com).
To Next Page
Loading...