EXXFIRE 750CNF - Removal CGG after an Event of Fire

version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 104
• Place the Used generator inside the packaging of the Unused one also using the plastic buffers
• Tape the lid of the box again fairly tight so it can’t
• Print the MSDS for the Used generator from our website
at https://exxfire.com/images/exxfire/MSDSExxFireUSEDGEN09N2.pdf
• Enclose the MSDS with transportation documents when shipping the generators back to the
Distributor
• In case there is no Distributor in your country please ship it back to EXXFIRE.
Removal of defective product
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• The qualified installer (distributor) has a decommissioning tool with which he can
decommission the system manually.
• The defective product must be removed and replaced with a new one.
• The defective product must be put in the box in which it was supplied (a 4G UN box) and
returned to the distributor of the applicable country (see a list at www.exxfire.com).
• The distributor decides whether to repair the product or supply a new product.
Removal CGG after an event of fire
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel familiar with the product and its documentation (product datasheet,