version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 27
3 SAFETY
General
The EXXFIRE® 750CNF/1500CNF/2250CNF contains pyrotechnic and chemical components that
are hermetically sealed off from the environment. These cannot be released under normal or
reasonably foreseeable conditions of use including proper disposal.
EXXFIRE products should only be handled by trained professionals. EXXFIRE provides specialist
training to all professional handlers through its distributors. The distributors are responsible for
providing the right training and correct information about the installation, handling and removal of
the product.
The EXXFIRE products are dependent on chemical technology from the Space Industry. This
technology necessitates special knowledge of the product to ensure a robust, safe, and functional
manufacturing
Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified and trained
personnel familiar with the product and its documentation (product datasheet, operating manual).
Incorrect handling or use of the product can cause serious damage and lead to serious injuries and
fatalities.
These guidelines with respect to the constituent materials apply to the EXXFIRE®
750CNF/1500CNF/2250CNF. The Material Safety Data Sheet of the generators can be found in
Appendix A.
• Do not handle the unit until all safety precautions have been read and understood
• Do not expose devices to temperatures above 85 C,
• Avoid all possible contact with grain inside device.
• Make sure that the unit is only handled in well ventilated areas.
• To prevent unnecessary initiation, keep the unit away from heat/sparks/open flames/hot
surfaces. Also, do not smoke in the enclosure where the unit is placed.
• Do not open, drill, incinerate, crush, immerse or expose to temperatures above range
reported for products.
• Avoid all contact with grain inside the unit.
• Do not bring the unit in contact with water, because of violent reaction and possible flash
fire (only applicable after usage).
• In case of fire: Use dry powder or sand for extinction.
• Avoid release to the environment
• Do not store together with combustible or oxidizing substances or mixtures.
• Dispose of the contents/container of the unit at an approved waste disposal plant
• Do not use the product beyond its design life in duration check www.exxfire.com.
To Next Page
Loading...