version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 114
13 DISPOSAL
• A damaged product (e.g. when dropped) results in a hazardous situation! Leakage of
chemicals, toxic release is possible! See: 3.8 how to handle in a hazardous situation.
• Treat product as chemical waste.
• Observe all federal, state, and local environmental regulations.
• Contact a licensed professional waste disposal service to dispose of this material.
• Contaminated packaging: dispose of as unused product.
The damaged CGG along with the collected spillage should be sealed in a bag and recycled as
chemical waste.
In the case where a used CGG is damaged (after gas has been deployed from it), the remaining
slack is highly reactive with water. The spilt material should be cleaned up according to the safety
data sheet by trained personnel following local guidelines and legislation. Typically, this may include
evacuating the immediate area, and wearing gloves and a dust mask while collecting the spilt
material using a dry dustpan and brush. It is imperative that the spilt material does not come into
contact with water. This could lead to a fire or explosive event.
The damaged CGG along with the collected spillage should be sealed in a bag and recycled as
chemical waste.
Disposal at end of life product
After removal from the protected space:
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel, familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• The distributor will organize the collection of the used system/generators in the respective
catchment area/region/country and takes care of the chemical waste disposal process on
behalf of EXXFIRE.
To Next Page
Loading...