version 4.7.2 – July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 116
Disposal after an event of fire
• Handling of the EXXFIRE® 750CNF/1500CNF/2250CNF must only be done by qualified
and trained personnel, familiar with the product and its documentation (product datasheet,
operating manual). Incorrect handling or use of the product can cause serious damage and
unsafe situations (serious injuries and possible fatalities).
• Where on-site CGG replacement is necessary; a CGG will be provided as a replacement unit.
As this is not protected by an outer enclosure, further care must be taken to handle it
appropriately, especially after it is removed from its transport packaging.
• The system must cool down.
• The CGG’s must be removed from the product,
• In case of a Used generator please ship them back to your local Distributor (see list on
website www.exxfire.com)
• Order a New and Unused generator and re-use the original packaging for shipping the
Used generator
• Take out the Unused generator from its UN certified packaging and install them in the
EXXFIRE fire protection system
• Take out the sticker for the return shipment of the Used generator and place them on
the UN certified box over the existing print
• Place the Used generator inside the packaging of the Unused one also using the
plastic buffers
• Tape the lid of the box again fairly tight so it can’t
• Print the MSDS for the Used generator from our website
at https://exxfire.com/images/exxfire/MSDSExxFireUSEDGEN09N2.pdf
To Next Page
Loading...