version 4.7.2 ā July 10th, 2022 Firmware version V2.1.7 and higher
EXXFIRE Installation and Service Manual 5
Mounting 37
4.4.1 Outside the protected enclosure mounting 37
4.4.2 Inside mounting 47
Electrical connections 55
4.5.1 Information and warnings 55
4.5.2 Install mains power cable 57
4.5.3 Install wiring for Connecting Systems 58
4.5.4 Install cable for Pre-alarm, Alarm and Fault outputs 61
4.5.5 Install wiring for Manual Activation Button input 63
4.5.6 Install wiring for Door Switch input 65
4.5.7 Connecting the Battery 68
Placement UI box 69
5 CONFIGURATION 72
Smoke Sensitivity 73
Extinguishing Gas Delay 74
Simultaneous Gas Release 75
Flow monitoring sensitivity 76
Manual Activation Button and Door Switch 76
Connected systems in a Master-Slave configuration 77
6 COMMISSIONING 79
Commissioning of the flow monitoring system 79
7 OPERATION 81
User Interface and key switch 82
Turning system ON and OFF and Resetting the system 90
Smoke detection and Alarm 91
Manual Activation Button 92
Door Switch 92
DISABLE Fire Extinguishing 93
Fire Extinguishing 95
Reset Alarm/Gas Released 96
Flow monitoring 97
Power Supply System including battery backup 98
Monitoring Cool Gas Generator status 98
Operation of connected systems 99
Service Intervals 100
System fault 100
Data logging 101
Disconnected display 101
To Next Page
Loading...