F.u.n.k.e. FSG 90 - Calling SET-UP With Password; Interrupting the SET-UP Procedure

FSG 90 System
5 SET-UP Procedure
40 FAV_D10024 December 2014
5.2 Calling SET-UP with password
Calling the SET-UP procedure with password must be carried out at radios, which are
protected by a password against unauthorized changes of the SET-UP adjustments.
 Turn OFF the radio (ON/OFF-VOL knob fully ccw).
 PUSH AND HOLD both MD and STO buttons, then turn ON the radio (rotate
ON/OFF-VOL knob clockwise, approximately mid position).
 All segments of the display appear for a short moment then the display gets blank.
 Release the buttons.
 After releasing the buttons the display shows in the upper line
alternately »FSG90« and »SET-UP«, in the lower line 5 dashes.
 If there is no activity for 60 seconds the radio returns to the mode
used before.
 With the F/CH knob set the first digit of your password (the first
dash changes to digit). Confirm the first digit by pushing the F/CH
knob. The second digit is ready to be adjusted.
 With the F/CH knob set the second digit of your password (the
second dash changes to digit). Confirm the second digit by
pushing the F/CH knob.
 Continue until all five digits of your password are entered.
 Confirm the last digit input by pushing the STO button. This will
open the SET-UP menu to adjust the squelch threshold.
Repeatedly pushing the MD button will open all other set-up
menus in the order described before.
 Entering a wrong password will return the SET-UP to the initial
status (5 dashes).
 After the fourth attempt to open the SET-UP with a wrong
password the radio returns to the operating mode used before
trying to open the SET-UP. The FSG 90(X) is operational.
5.3 Interrupt the SET-UP procedure
The SET-UP procedure may be interrupted any time:
 Usually by turning OFF the power (ON/OFF-VOL knob fully ccw). All changed and
individually stored adjustments (by pushing the STO button) are permanently stored
and effective after turning ON the radio again.
 or by pushing the Transfer button (). The radio returns to the operating mode used
before. All changed and individually stored adjustments up to now (by pushing the
STO button) are permanently stored and effective.