F.u.n.k.e. FSG 90 - Resetting FSG 90 to Factory Settings

FSG 90 System
5 SET-UP Procedure
48 FAV_D10024 December 2014
5.4.14 Reset
CAUTION!
Every RESET to the factory setting
 deletes all your pre-set memory channels 5 to 99 (in both
‘8.33/25 kHz’ and ‘25 kHz only’ Mode)! Memory channels 1 - 4
get programmed with 118.00 or 118.005 respectively
 deletes your password!
 delete all your individual SET-UP adjustments!
To reset all adjustments proceed as follows:
 Turn OFF the radio (ON/OFF-VOL knob fully ccw).
 PUSH AND HOLD simultaneously the buttons MD, STO and SQ, then turn ON
the radio (rotate ON/OFF-VOL knob clockwise, approximately mid position).
 All segments of the display appear for a short moment then the display gets blank.
 Release the buttons.
After releasing the three buttons the display shows in the upper line
alternately »SET« and »RESET«, in the lower line »0«.
If there is no activity for 60 seconds the radio will return to the mode
used before.
With the F/CH knob set lower line to "1".
Confirm RESET by pushing the STO button.
The upper segment of the On-board Supply Indicator will light up
shortly.
 The VHF radio FSG 90(X) is now operable in the factory setting.