Digital Brushless AC Servo Drive system - Ref.1609 ACSD-23/80
Holding brake
FKM motors have an optional holding brake that applies friction to the shaft. Its purpose
is to immobilize or lock vertical axes, not to brake a moving axis.
Technical data
Its main characteristics depending on the type of brake are:
T. 9 Technical data of the holding brake.
Motor Holding
torque
Power
consumption
ON/OFF
time
Range of
releasing
voltage
Inertia Mass
approx.
Units N·m lbf·ft W hp ms V DC kg·cm² kg lbf
FKM2 4.5 3.32 12 0.016 7/35 22-26 0.18 0.30 0.66
FKM4 9.0 6.64 18 0.024 7/40 22-26 0.54 0.48 1.06
FKM6 18.0 13.28 24 0.032 10/50 22-26 1.66 0.87 1.92
Note. Maximum speed for all ot them is 10000 rev/min.
WARNING. NEVER use this holding brake to stop a moving axis.
WARNING.
The holding brake must never exceed its maximum turning speed.
Voltage between 22 and 26 V DC releases the shaft. Make sure that no
voltage over 26 V DC is applied that prevents the shaft from turning.
When installing the motor, make sure that the brake fully releases the
shaft before making it turn for the first time.
To Next Page
Loading...
