Fagor CNC 8070 - Page 55

E
XAMPLES MANUAL
Chapter 2
Page 49 of 96
Conversational
programming
Exercise 5. 3D
pockets with islands
CNC 8070
With what has been previously programmed, the outside contour of the geometry and the island
would already be defined.
Then, use the P.Z1 and P.Z2 boxes to do the pocket's depth profile.
P. Z 1
BEGINNING
X=-30 Z=0 VALIDATE
STRAIGHT
X=-25 Z=-15 VALIDATE
END
SAVE PROFILE
P. Z 2
BEGINNING
X=-9 Z=-15 VALIDATE
STRAIGHT
X=-5 Z=-4 VALIDATE
END
SAVE PROFILE