User’s Manual
56
Once the clip copy starts, you can cancel it by selecting Cancel or hide the screen by selecting Close. When selecting
Close, Clip Copy continues and a confirmation screen will display when complete.
NOTE: The file size for clip copy is limited to 30GB. When copying video clips larger than 2GB, the video clips
will be save in units of 2GB. For example, 3 individual 2GB files will be created when saving a 6GB video clip.
However, the file size for the One-Touch Clip Copy is limited to 2GB.
You can use other functions on the DVR while video is being backed up. To do this, highlight the Close button and
press the
button. You can return to the Clip-Copy screen at any time to check the progress.
You do not need to install any special software on your personal computer to review the video clips. Refer to the RAS
manual for instructions on how to review video clips you have copied.
NOTE: During Clip Copy, you cannot shut the system down, clear data on the storage device, or format the
storage device.
CAUTION: Do NOT disconnect the USB cable or the power from the external drive while copying video
clips. If the external drive is shut down or the USB cable is disconnected while copying video clips,
THE DVR SYSTEM MAY NOT WORK NORMALLY OR THE EXTERNAL DRIVE COULD BE DAMAGED,
and you will get an error message the next time you try to copy video clips. You will need to power
down the DVR and restart it to get rid of the error message. Once the file system of the USB hard
disk drive has been corrupted, this error message cannot be dismissed. Even after restarting the
DVR it may automatically restart while preparing to clip copy. You must recover the file system using
the recovery program, or you must reformat the hard disk drive.
To Next Page
Loading...
