TAKE CARE WHEN CLEANING NOT TO DISLODGE OR DAMAGE THERMOSTAT
PROBES MOUNTED ON THE BASE AND SIDE OF THE PAN.
DISLODGING OR DAMAGING THE THERMOSTAT PROBES OR THEIR
CAPILLARIES CAN INCREASE THE RISK OF OVERHEATING OR FIRE.
IF THE THERMOSTATS OR CAPILLARIES ARE DAMAGED THEN DO NOT TURN
THE APPLIANCE ON. CONTACT FALCON OR YOUR APPROVED SERVICE
PROVIDER TO UNDERTAKE THE NECESSARY REPAIRS.
Location of Safety and Operating Thermostat Probes
11.
Slide up the oil level sensor guard (G3840X/G3840FX only).
Oil level sensor guard raised for cleaning
12.
Clean guard and sensor probe using a soft clean cloth and hot soapy water
(G3840X/G3840FX only).
NOTE: Care should be taken not to damage the oil level sensor probe located at the
front of the pan.
13.
Open drain valve. Drain water into bucket below.
14.
Use clean water to rinse fry pot and dry thoroughly.
15.
Close drain valve.
16.
Return crumb catcher, fry plate and baskets to pan.
17.
Slide down oil level sensor guard (G3840X/G3840FX only).
To Next Page
Loading...
