BEFORE ANY CLEANING IS UNDERTAKEN, ISOLATE APPLIANCE FROM MAINS POWER
SUPPLY AT ISOLATOR SWITCH.
SUITABLE PROTECTIVE CLOTHING MUST BE WORN WHEN CLEANING THIS
APPLIANCE.
NEVER PUMP WATER THROUGH THE FILTRATION PUMP AT ANY TIME! WATER AND HOT
OIL ARE AN EXPLOSIVE MIXTURE.
OIL MUST BE ALLOWED TO COOL TO A SAFE TEMPERATURE BEFORE DRAINING. DO
NOT OVERFILL OIL BUCKET. ALL SPILLS ONTO THE PRODUCT AND ON THE FLOOR SHOULD
BE CLEANED UP IMMEDIATELY.
THE APPLIANCE MUST NOT BE CLEANED WITH A JET OF WATER OR BE STEAM
CLEANED. DO NOT
USE ACID OR HALOGEN-BASED (E.G. CHLORINE) DESCALING
LIQUIDS, FLAMMABLE LIQUIDS,
CLEANING AIDS OR CLEANING POWDERS.
FAILURE TO CLEAN AND CHECK THE SAFETY AND OPERATIONAL THERMOSTATS
CAN IMPACT THE PERFORMANCE OF THE APPLIANCE AND INCREASE THE RISK OF
AN APPLIANCE FIRE.
FAILURE DUE TO LACK OF PROPER CLEANING IS NOT COVERED BY WARRANTY.
Note: All surfaces are easier to clean if spillage is removed before it becomes burnt on, cleaned
daily.
Stainless Steel Surfaces
It should be noted that certain scouring pads including nylon types, could easily mark stainless
steel. Care should be exercised during cleaning process.
When rubbing stainless steel with a cloth, always rub along in grain direction.
The following procedure should be undertaken, AT LEAST DAILY.
8.1 CLEANING THE APPLIANCE
1.
Carry out actions detailed in Sections 8 and 9.
2.
Unit should be switched OFF and fry pot drained of oil.
3.
Remove baskets, fry plate and crumb catcher.
Soak these components in hot soapy water.
4.
With drain valve open, remove any traces of debris from fry pot using a clean, damp cloth.
NOTE: Care should be taken not to damage sensors located at pan front.
5.
Remove strainer and micro-filter, soak these in hot soapy water.
6.
Wash, rinse and dry removed items thoroughly.
Set these aside.
7.
Close drain valve.
8.
Fill fry pot to 3/4 full with hot water.
9.
Clean pan using a soft, clean cloth and hot soapy water. Rub away any stubborn staining
with a scouring pad and suitable detergent.
10.
Clean the safety and operating thermostats removing any food debris from around the
thermostats which could detrimentally affect the performance and safety of the appliance.
To Next Page
Loading...
