ADJUST NOZZLES Liquid Fertilizer Applicator A10 / A13 / A18 / A24 Page 61
ADJUST NOZZLES
A. Setscrew
B. Setscrew
1. Extend the wings and raise the
toolbar to its fully up position.
2. Place safety stands under the center
of the toolbar or install cylinder
transport locks on the lift cylinders.
3. To adjust nozzle angle:
a. The best results are obtained
when the nozzle directs liquid
approximately 1 inch (25 mm)
behind the coulter.
b. Loosen setscrew (A) to set
the nozzle at the required
angle and centered behind
the coulter.
4. To adjust nozzle spray pattern:
a. Sight along the nozzle and
coulter. The nozzle should
direct liquid directly behind
the coulter.
b. Loosen setscrew (B) to adjust
the nozzle spray parallel with
a furrow.
5. As a general guideline, the tip of the
nozzle should be slightly above the
ground as the unit moves over the
field. This will ensure that liquid
enters the soil via a furrow and is
retained in the soil as the furrow
closes.
Check chemical or fertilizer M/SDS for
proper handling instructions.
Toxic chemicals can enter the body by
breathing spray or contact with bare skin.
To Next Page
Loading...
Need help?
General