FILLING THE TANK Liquid Fertilizer Applicator A10 / A13 / A18 / A24 Page 63
FILLING THE TANK
CAUTION: Prevent serious injury or
death.
Check chemical or fertilizer M/SDS for
proper handling instructions.
Toxic chemicals can enter the body by
breathing spray or contact with bare skin.
Do not take a chance with your health and
safety.
Filling the Product Tank
A. Fill line
IMPORTANT: Transport the machine
with an EMPTY tank to prevent
machine damage.
CAUTION: Add only the amount of
liquid to the tank that is required for
the job.
1. Position a tender truck or a drive truck
next to machine.
2. Remove the fill line’s (A) covers.
3. Connect a transfer hose to the
bottom fill line.
4. Start the pump on the tender truck
and open the valve on the fill line.
5. Pump until the tank is filled to the
desired level. Do not overfill.
6. Close the input valve and stop the
pump on the tender truck.
7. Remove and stow the transfer hose.
8. Install and fasten the fill line’s covers.
Filling Fresh Water Rinse Tank
A. Rinse Tank
Each machine is equipped with a freshwater
rinse tank (A) on the rear frame. Fill the rinse
tank with clean freshwater whenever rinse
water has been used. Do not allow this tank
to run low on fresh water.
Use water from the rinse tank to clean, rinse
or, wash anything that has become
contaminated.
WARNING: Do not drink the water
from the rinse tank.
The rinse tank water may become
contaminated with sprayer chemicals or
other contaminates.
To Next Page
Loading...
Need help?
General