Fastech Ezi-Step Plus-R

- 10 6 -
106
Library for PC Program
FAS_PosTableRunItem
To perform command from a specific item in the position table
Syntax
int FAS_PosTableRunItem(
BYTE nPortNo,
BYTE iSlaveNo,
WORD wItemNo
);
Parameters
nPortNo
Port number of relevant drive.
iSlaveNo
Slave number of relevant drive.
wItemNo
Item number to start motion
Return Value
FMM_OK : Command has been successfully performed.
FMM_NOT_OPEN : The drive has not been connected yet .
FMM_INVALID_PORT_NUM : There is no nPort in the connected ports .
FMM_INVALID_SLAVE_NUM : There is no drive of iSlaveNo in the relevant port .
FMM_INVALID_PARAMETER_NUM : wItemNo is out of range.
Remarks
Example
See Also
FAS_GetAllStatus
FAS_MoveStop
FAS_EmergencyStop