Fastech Ezi-Step Plus-R User Manual

- 76 -
76
Library for PC Program
FAS_GetAxisStatus
To read the motor Axis Status value. For status Flag, refer to ‘1-1-5. Frame Type and
Data Configuration’.
Syntax
int FAS_GetAxisStatus(
BYTE nPortNo,
BYTE iSlaveNo,
DWORD* dwAxisStatus
);
Parameters
nPortNo
Port number of relevant drive.
iSlaveNo
Slave number of relevant drive.
dwAxisStatus
Parameter pointer where the axis status value of the relevant motor
Return Value
FMM_OK : Command has been successfully performed.
FMM_NOT_OPEN : The drive has not been connected yet .
FMM_INVALID_PORT_NUM : There is no nPort in the connected ports.
FMM_INVALID_SLAVE_NUM : There is no drive of iSlaveNo in the relevant port .
Remarks
Example
Refer to ‘FAS_MoveSingleAxisAbsPos ’ library.
See Also

Fastech Ezi-Step Plus-R Specifications

General

Brand	Fastech
Model	Ezi-Step Plus-R
Category	Controller
Language	English