Fastech Ezi-Step Plus-R

- 88 -
88
Library for PC Program
FAS_PositionIncOverride
To change the incremental position value set while the motor moves to the incremental
position
Syntax
int FAS_PositionIncOverride(
BYTE nPortNo,
BYTE iSlaveNo,
long lOverridePos
);
Parameters
nPortNo
Port number of relevant drive.
iSlaveNo
Slave number of relevant drive.
lOverridePos
Incremental coordinate position value to be changed
Return Value
FMM_OK : Command has been successfully performed.
FMM_NOT_OPEN : The drive has not been connected yet .
FMM_INVALID_PORT_NUM : There is no nPort in the connected ports .
FMM_INVALID_SLAVE_NUM : There is no drive of iSlaveNo in the relevant port .
Remarks
Refer to ‘FAS_PositionAbsOverride ’ library.
Example
Refer to ‘FAS_MoveSingleAxisAbsPos ’ library.
See Also
FAS_PositionAbsOverride