(2) Wrong Command
FMP_RUNFAIL = 0x85,
Fail on motion command : Tried to new motion under following status .
-. The motor is already running
-. The motor is under stop command
-. Try to Z-pulse Origin without external encoder (only for Ezi -STEP)
FMP_RESETFAIL,
Fail on reset command : Tried to new motion under following status .
-. Already ‘Reset’status by external input signal.
(3) Command Execution Error
FMM_POSTABLE_ERROR,
The execution of DLL library for ‘Position Table’is failed.
To Next Page
Loading...
