Feasa 3-F - Get Intensity Mode Status

FEASA LED ANALYSER
FUNCTIONAL VERSION
Get Data Mode
getintensitymode - Get which Intensity Mode is active Logarithmic or Linear
Transmit Receive
getintensitymode Log or Lin
Where: Log is the Logarithmic Mode and Lin is the Linear Mode
Description
The Led Analyser is shipped from the factory in Logarithmic Mode. However it is possible to
change the mode to Linear by using the commands set/putlin. To reset the analyser back to
log mode use the command set/putlog.
Refer to pages 10,11 of this document for more details
Example:
Connect the Led Analyser to the Feasa Terminal Window and type getintensitymode. The
Analyser will report the mode the Intensity output of the Analyser is set to.
Set the Analyser is Linear mode and verify.
putLin
getintensitymode
Linear
Back to Index
41