Feasa 3-F - Get Intensity Gain Factor

FEASA LED ANALYSER
FUNCTIONAL VERSION
User Calibration Mode
getINTGAIN## - Get the Intensity Gain Factor
Transmit Receive
getIntGain## xxx
Where:
## represents the Fiber Number and is a number in the range 01 – 20.
xxx represents the Intensity gain value. Default 100.
Description
This command is used to get the Intensity gain value for each Fiber.
The default values set at the factory are 100 i.e. 100% of nominal. The values can be
adjusted by the SetIntGain command.
Example:
The PC transmits getintgain01 to the LED Analyser to instruct it to send the stored intensity
gain data for Fiber No 1.
getintgain01
100
Back to Index
59