FEASA LED ANALYSER
FUNCTIONAL VERSION
General Commands
getBAUD- Get the Baud Rate
Transmit Receive
getBAUD X bps
Where: X = 9600, 19200, 38400, 57600, 115200 for Serial RS232 Port
Where: X = 9600, 19200, 38400, 57600, 115200, 230400, 460800, 921600 for USB Port
Description
This command will get the baud rate of the Serial and USB Port's that the Analyser is
communication through.
The default Port settings of the Analyser are 57,600, 8 Data bits, 1 Stop bit and No Parity.
It can also be seen on the comment section of the Feasa terminal window.
Example:
To get the baud rate of the Analyser transmit the command getbaud to the Analyser.
getbaud
57600 bps
Back to Index
43
To Next Page
Loading...