TST_FUZ2-A-B-C-CX-G-L_Montageanleitung_EN_22.docx
An electrician is qualified to work in the working
environment of electrical systems; their knowledge and
experience enable them to perform and monitor electro-
technical work without danger. The electrician is familiar
with the relevant standards and specifications and knows
the specifications of the valid legal regulations pertaining to
accident prevention. They take part in regular measures of
further training.
Electricians currently undergoing training (also minors) are
only permitted to perform work under the supervision of an
experienced electrician; this requires the express
permission of the operating company.
▪ Unpacking
▪ Assembly
▪ Installation
▪ Commissioning
▪ Repair
▪ Operation
▪ Programming
▪ Disposal
▪ Instruction
The manufacturer is involved in the design and production of
a partly completed machine and accepts responsibility for
conformity of the machine part with the directive.
▪ Design
▪ Production
▪ Disposal
The distributor provides a complete machine to the market in
terms of its distribution or use.
1.4 Duty of care of the operating company
FEIG ELECTRONIC GmbH maintains a certified quality management system in accordance with DIN EN ISO
9001.
The faultless safety condition of the controller and its function are checked in accordance with valid regulations
before it leaves our factory. The operating company is to check this state after transport and before assembly of
the controller.
The operating company is responsible for maintaining this state by ensuring that
• The controller is installed in accordance with the assembly, installation and safety regulations outlined
here.
• Damage is rectified immediately by qualified specialist personnel.
• The controller is operated in a faultless state.
• The controller is assembled, installed and commissioned by qualified specialist personnel only.
To Next Page
Loading...
Need help?
General
