34
212UBB
212VZT
212UAB
#
"
!
$
!
Planer-Thicknesser
A 941 / AD 941 / AD 951
The planing height can be adjusted continuously bet-
ween 3 and 250 mm (254 mm).
The set value is displayed on the digital display resp.
the digital indicator with an accuracy of 0,1 mm.
!Digital clock
"“Power-Drive” equipment (AD 941)
#“Power-Drive” equipment (AD 951)
$“Digi-Drive” equipment (AD 951)
Note: The maximum chip thickness per work cycle is 5 mm.
To compensate for the thread clearance, adjust the thicknessing table from bottom to top.
The maximum depth of cut is directly related to the following factors:
• Workpiece width
• Type of wood (hardwood or softwood
• Wood dampness
• Feed rate
• Cutterblock (2 or 4 Cutterblock Possibilities)
• Cutterblock Possibilities (SS, HS, HW)
• The motor power of your machine
Fig. 8-7: Varieties of control
8.6 Adjust the thicknessing height
Attention! Risk of material damage!
When setting the thicknessing infeed hight (particularly when lowering), be sure that no workpieces or
other objects have been placed beneath the table (wedging threat).
Making adjustments and preparations
To Next Page
Loading...