Felder A 941 - Maintenance Schedule and Safety; Safety Instructions for Maintenance; Maintenance Schedule

50
!
Planer-Thicknesser
A 941 / AD 941 / AD 951
Interval Component Task to accomplish
Daily Machine Remove dust and shavings.
Table surfaces, Planer fence Remove dust and shavings. Remove any resin residue
Dust extractor Check for defects
Kickback guards Check if functioning, Remove residual resin if necessary
Weekly Machine, Feed rollers Clean thoroughly
Monthly Dust extractor Check efficiency
Safety devices
(EMERGENCY STOP button)
When the machine is running: Check efficiency
Press the EMERGENCY-STOP button.
The machine is stopped automatically. *)
Safety devices
(Safety break switches)
Check efficiency
See chapter entitled - General maintenance instructions
every 6 months Chain (Gearbox, Height spindle) Check and lubricate if necessary
Friction wheel (Gearbox) Check and exchange if necessary
Drive belt Check and if required, tighten or change
*1) The unit must stop with the clamped tool after 10 seconds.
Please contact the FELDER KG service department, if problems or a fault- function should occur!
10 Maintenance
10.1 Safety instructions
10.2 Maintenance schedule
Service
Attention! Risk of material damage!
The following maintenance has to be carried out according to the instructed time intervals!
• Before beginning any maintenance work on the
machine, switch it off and secure it against accidentally
being switched on again.
• Keep the work area orderly and clean. Components
and tools that are not put in their correct place or put
away may be the cause of accidents!
• Ensure that there is sufficient space to work around the
machine.
• Following the maintenance work, reinstall the guards
and check that they are functioning properly.
Warning! Risk of injury!
Improper maintenance can cause serious injury or damage.
For this reason, this work may only be carried out by authorised, trained personnel who are familiar with how
to operate the machine and in strict observance of all safety instructions.
Warning! Danger! Electric current!
Work on electrical fittings may only be carried out by qualified personnel and in strict observance of the safety
instructions.