49
!
Planer-Thicknesser
A 941 / AD 941 / AD 951
at the end of the
workpiece when thickness planing:
1. The workpiece must be supported when it comes out of
the rear of the machine to prevent it from tipping over.
2. If you are not going to continue working, switch off the
machine and secure it against being turned on again
accidentally.
3. AD 941: Set the gear lever to the “0” setting.
!Table extension
Fig. 9-11: Thickness planing
Operation
Note: For easy handling, use the table extensions
See: Tools and Accessories catalogue
To Next Page
Loading...
