Festo Distributing Station - Default Chapter; Table of Contents

© Festo Didactic GmbH & Co. KG  3
1. Introduction ____________________________________________________ 5
1.1 Training contents ________________________________________________ 6
1.2 Important notes _________________________________________________ 7
1.3 Duty of the operating authority _____________________________________ 7
1.4 Duty of trainees __________________________________________________ 7
1.5 Risks involved in dealing with the Modular Production System ___________ 8
1.6 Warranty and liability _____________________________________________ 9
1.7 Intended use ____________________________________________________ 9
2. Notes on safety _________________________________________________ 11
3. Technical data _________________________________________________ 13
3.1 Combinations __________________________________________________ 13
4. Transport/Unpacking/Scope of delivery ___________________________ 15
5. Design and function _____________________________________________ 17
5.1 The Distributing station __________________________________________ 17
5.2 Function _______________________________________________________ 19
5.3 Sequence description ____________________________________________ 19
5.4 Stack magazine module __________________________________________ 20
5.5 Changer module ________________________________________________ 21
6. Commissioning _________________________________________________ 23
6.1 Workstation ____________________________________________________ 23
6.2 Mechanical set up _______________________________________________ 24
6.2.1 Assembling profile plate and control console ________________________ 24
6.2.2 Assembling the station ___________________________________________ 25
6.3 Adjust sensors __________________________________________________ 26
6.3.1 Proximity sensor (Stack magazine, ejecting cylinder) __________________ 26
6.3.2 Through-beam sensor (Stack magazine, filling level) __________________ 27
6.3.3 Micro switch (Changer, swivel drive) _______________________________ 28
6.3.4 Vacuum switch (Changer, vacuum suction cup) ______________________ 29
6.4 Adjusting one-way flow control valves ______________________________ 30
6.5 Visual check ____________________________________________________ 30
6.6 Cable connections _______________________________________________ 31
6.7 Pneumatic connection ___________________________________________ 32
6.7.1 Manual override ________________________________________________ 32
6.8 Voltage supply _________________________________________________ 32
Contents