Festo MPA Series - Page 65

2. Fitting
2−9
Festo P.BE−MPA−EN en 0910d
1 H−rail
2 Clamping
component of the
H−rail clamping
unit
1
2
Fig.2/2: Rear view: H−rail mounting, using the CPX terminal as an example
Information on mounting the MPA−S valve terminal with CPX
terminal can be found in the CPX system description.
Dismounting Proceed as follows:
1. Loosen the retaining screw of the H−rail clamping unit
(forposition of the screws, see Tab.2/2). Make sure that
the clamping component lies horizontally with respect to
the H−rail.
2. Swing the MPA−S valve terminal forwards away from the
H−rail (see Fig.2/3).
3. Lift the MPA−S valve terminal away from the H−rail
(seeFig.2/3).