111
WARNING The backrest is correctly
secured when the red band on the
backrest folding handles (A) fig. 139
disappears. The red band indicates
that the backrest is not secured.
WARNING After putting the rear seats
(for versions/markets, where provided)
back to their normal operating position,
re-position the seat belt so that it is
immediately ready for the next use.
76)
WARNING
74)
Never press button (C) fig. 137 when
travelling.
75)
Remember that in the event of a
violent impact the rear seat passengers
not wearing seat belts are exposed to
a very serious risk and also represent
a serious danger for the front seat
occupants.
76)
Make sure the backrest is properly
secured at both sides (”red bands” not
visible) to prevent it moving forward in the
event of sharp braking, causing injuries to
passengers.
SBR SYSTEM
(for versions/markets, where provided)
It consists of an acoustic warning
which, switching on the warning
lights in the trim located on the internal
rear view mirror, warns passengers in
the front and rear seats that their seat
belts are not fastened.
141 F0T0989
For long-term deactivation of the SBR
system, contact a Fiat Dealership.
The SBR system can be reactivated at
any time through the Setup Menu only
(see the "Multifunction display" chapter
in the “Knowing your vehicle” section).
The warning lights may be red or green
and operate as:
1 = front left seat (driver status for
left-hand drive versions)
2 = rear left seat (passenger) (for
versions/markets, where provided);
3 = middle rear seat (passenger) (for
versions/markets, where provided);
4 = rear right seat (passenger) (for
versions/markets, where provided);
5 = front right seat (passenger status
for left-hand drive versions).
NOTE On versions equipped with sport
front seats, the indication of passenger
side seat belt fastened (warning light 1
for right-hand drive versions or warning
light 5 for left-hand drive versions) will
never be displayed.
FRONT SEATS (warning
light 1 = driver and 5 =
passenger)
Driver
If the driver is the only occupant of
the vehicle and the seat belt is not
fastened, when 20 km/h is exceeded
or when travelling at a speed from 10
to 20 km/h for longer than 5 seconds,
a buzzer sequence will be started
(front seats) consisting of a tone for 6
seconds followed by a 90 second
beep. The warning light will blink.
The warning lights will stay on
constantly at the end of the cycle until
the engine is stopped. The acoustic
warning will be interrupted immediately
when the driver’s seat belt is fastened
and the warning light will turn green.
The reminder cycle (acoustic and
visual) will be repeated as described
above and the red warning light will
To Next Page
