145
HAZARD WARNING
LIGHTS
They are turned on by pressing switch
(A) fig. 173, regardless of the position
of the ignition key.
Warning lights and are lit up in
the instrument panel when this device
is activated. Press the switch (A) again
to turn the lights off.
WARNING The use of hazard warning
lights is governed by the highway code
of the country you are in. Comply with
legal requirements.
173 F0T0049
Emergency braking (for
versions/markets where provided)
In the event of emergency braking
the hazard warning lights come on
automatically, as do the and
warning lights in the panel. The function
switches off automatically when the
nature of the braking changes.
This function complies with the relevant
legislation currently in force.
CHANGING A WHEEL
The vehicle is originally equipped with
the Fix&Go Automatic quick tyre repair
kit (see instructions in the next section).
As an alternative, the vehicle may have
a normal-sized spare wheel.
Wheel changing and correct use of
the jack and spare wheel call for some
precautions, as listed below.
121) 122) 123) 124) 125) 126) 127)
27) 28)
JACK
Please note that:
the jack weight is 1.76 kg;
the jack requires no adjustment;
the jack cannot be repaired and in
the event of a fault it must be replaced
by another genuine one;
no tool other than its cranking device
may be fitted on the jack.
WHEEL REPLACEMENT
PROCEDURE
To change a wheel, proceed as
follows:
stop the vehicle in a position that is
not dangerous for oncoming traffic
where you can change the wheel
safely. The ground must be flat and
sufficiently compact;
switch off the engine and pull the
handbrake;
engage first gear or reverse;
before getting out of the vehicle,
put on the reflective safety jacket (if
required by the regulations in force). In
any case, follow the road safety laws
in force in the country where you are
driving;
indicate that the vehicle has broken
down using the devices required by the
law in the current country (e.g. warning
triangle, hazard lights, etc.);
For Fiorino Cargo versions: lift lever
(A) fig. 174 and move the left front
set backrest forward to retrieve the
tool bag located behind the backrest:
release the elastic strap and take the
tool bag to the wheel to be changed;
174 F0T0119
for Fiorino Combi and Qubo versions:
open the rear swing doors, take the
To Next Page
Loading...
