KNOWING YOUR VEHICLE
34
Rear ceiling light: on manually.
Removable ceiling light (alternative to
rear ceiling light): on manually (fixed
part).
Ceiling lights off when locking the doors
Front and rear ceiling light (also with
optional removable ceiling light): off
(faded out) when the sliding side doors,
rear swing doors or front doors are
closed.
With independent load compartment
Front ceiling light: fades out when the
front doors are closed.
Rear ceiling light (also with optional
removable ceiling light): off (faded out)
closing the rear doors.
Combi versions
The ceiling lights switch on/off in the
following ways:
Ceiling lights on without locking the
doors
Front ceiling light: comes on when the
front doors are opened.
Rear ceiling light: on manually.
Ceiling lights off when locking the doors
Front and rear ceiling light (also with
optional removable ceiling light): off
(faded out) when the sliding side doors,
rear swing doors or front doors are
closed.
WINDOW WASHING
The right stalk fig. 46 controls
windscreen wiper/washer and rear
window wiper/washer operation (for
versions/markets, where provided).
WINDSCREEN WIPER/
WASHER
This operates only with the ignition key
turned to MAR.
The ring on the right stalk can assume
five different positions:
windscreen wiper off.
flick operation.
continuous slow operation.
continuous fast operation.
Move the stalk to position (A) fig. 46
(unstable) to limit operation to the
time for which the stalk is held in this
position.
46 F0T0432
When released, the stalk will return to
its default position and the windscreen
wiper will be automatically stopped.
With the ring in position fig. 46,
the windscreen wiper will automatically
adapt to the vehicle speed.
With the windscreen wipers
operational, if reverse gear is engaged,
the rearscreen wiper is automatically
activated.
3)
“Smart washing” function
Pull the stalk towards the steering
wheel (unstable position) to operate the
windscreen washer.
Keeping the stalk pulled for more than
half a second, with just one movement
it is possible to operate the washer jet
and the wiper at the same time.
The windscreen wiper stops working
three strokes after the stalk is released.
A further stroke after approx. 6
seconds completes the wiping cycle.
Service Position function
This function (which can only be
activated after the engine has stopped)
makes it possible to replace the blades
or protect them when there is ice
and/or snow.
The "Service Position” function can be
requested explicitly within two minutes
of stopping the engine, when the
wipers have returned correctly to their
parked position.
The function can be activated by
turning the ring to position and
To Next Page
Loading...
