27
then push the backrest (B) fig. 27
down: the seat is now completely
folded over on itself into the "table"
position;
pull tab (C) fig. 27 and push the
backrest down further: the seat is now
completely folded away.
Repositioning the seat
To return the seat back to its normal
position, proceed as follows:
take tab (C) fig. 27 and lift the
backrest up;
operate levers (B) fig. 28 and further
lift the seat upwards.
16) 17)
28 F0T0237
REAR SEATS
(for markets/versions, where provided)
Access to the rear seats
(Combi versions)
To access the rear seats, open one
of the sliding side doors (see "Doors"
chapter in this section).
WARNING
13)
All adjustments must be made with the
vehicle stationary.
14)
After releasing the adjustment lever,
always check that the seat is locked on
the guides by trying to move it back and
forth. If it is not locked, the seat may move
unexpectedly and make you lose control of
the vehicle.
15)
Do not place objects on the seat or
on the backrest that may isolate the heat,
such as a cover or a pillow. It may cause
the seat heating device to overheat. Sitting
on an overheated seat may cause severe
burns due to the increase in temperature
of the seat surface.
16)
When the passenger seat is folded
away, the space created cannot be used
for loading. When the vehicle is in motion,
you are therefore advised to remove or
secure any objects that might interfere with
the driver. If there is no partition between
the cab and the load compartment, tall
objects or packages may take up part
of the passenger area. Make sure that
these items are well secured by using
the available hooks and that they cannot
interfere with the driver.
17)
If there is no partition between the cab
and the load compartment, tall objects
or packages may take up part of the
passenger area. Make sure that these
items are well secured by using the
available hooks and that they cannot
interfere with the driver.
HEAD RESTRAINTS
FRONT
29 F0T0053
These are height-adjustable and lock
into place automatically fig. 29.
Upward adjustment: lift the head
restraint until it clicks into place.
Downward adjustment: press button
(A) fig. 29 and lower the head restraint.
18)
REAR
(for versions/markets, where provided)
Lift up to use.
To put the headrests away, press
buttons (A) fig. 30 and fig. 31 and push
them down into the backrest.
To Next Page
Loading...
