KNOWING YOUR VEHICLE
28
30 F0T0054
N1 versions (4 seats) fig. 31
31 F0T0341
To extract the headrests, raise them
until you hear the click (which indicates
they are in "all extracted" position).
WARNING The headrests must always
be in the "all extracted" position when
the rear seats are in use.
WARNING
18)
All adjustments must be carried out
only with the vehicle stationary and the
engine off. Head restraints must be
adjusted so that the head, rather than the
neck, rests on them. Only in this case
they can protect your head correctly. To
maximise the protective action provided by
the headrest, adjust the seat back so that
your trunk is upright and keep your head
as close to the headrest as possible.
STEERING WHEEL
The height and axial position of the
steering wheel can be adjusted on
some versions.
To carry out the adjustment, proceed
as follows:
release lever (A) fig. 32 by pushing it
forwards (position (1));
adjust the steering wheel;
lock the lever (A) by pulling it towards
the steering wheel (position (2)).
19) 20)
32 F0T0040
WARNING
19)
All adjustments must be carried out
only with the vehicle stationary and the
engine off.
20)
It is absolutely forbidden to carry
out any aftermarket operation involving
steering system or steering column
modifications (e.g. installation of anti-theft
device) that could adversely affect
performance, invalidate the warranty,
cause serious safety problems and
also result in the vehicle not meeting
type-approval requirements.
To Next Page
Loading...
